To design the
angels, start by cutting out vellum paper for small messages. You can label these with personal messages first and then roll them up. Carefully place each roll in the
test tube. This way, the contents remain hidden at first.
Tie about 30 cm of enameled copper wire around the middle of the angel wings. Put some hot glue in the middle and press the test tube onto it. Then wrap the wire around the test tube and twist the ends.
Cut out a banner from the vellum paper and stamp with the
XL "Christmas Wishes" stamp set and the waterproof ink pads "Staz-On". Use a hole punch to punch a small hole and pull the wire through the banner. Wrap the remaining wire around a bamboo skewer to form a pretty spiral.
For the
trio of hats, print out the template and then cut out the shapes. transfer them onto craft felt using a sublimation pen and cut out the individual hats. Glue the beard with VBS handicraft glue onto the test tube and place the wooden hemisphere on top.
Cut vellum paper , roll it up and stick it into the tube. Finally, pull the cap over the cork.
